High School Workout training 5

  • Weeks 1-6 of Macrocycle 1 for Foundational training.
  • This is a twice a week resistance program.
  • Do 5-10 minutes of a dynamic warm-up.
  • Complete in supersets of 2-3 exercises with 45 seconds rest between exercises.
  • Rest 1-2 minutes between sets.

Deep Squat (barbell)

1. Grasp bar with overhand grip (palms forward) and slightly wider than hip width apart. Step under bar and position bar across posterior deltoids at middle of trapezius (as shown). DO NOT rest bar on neck. Lift elbows up, pull shoulder blades together, and lift chest up to create a “shelf” for the bar.
2. Start position: Using the legs, remove bar from rack. Stand with feet slighter wider than hip width apart. Back should be straight in a neutral position.
3. Lower body by flexing at the hips and knees. Upper body can flex forward at the hips slightly (~5°) during movement. Be sure to “sit back” so that knees stay over the feet.
4. Once thighs are below parallel to floor, return to start position.
5. Remember to keep head and back straight in a neutral position - hyperextension or flexion may cause injury. Keep weight over the middle of foot and heel, not the toes.
6. DO NOT allow knees to go past the big toe or deviate medially or laterally throughout movement. Keep abdominals tight throughout exercise by drawing stomach in toward spine.

Barbell Incline Chest Press

1) Lie back onto incline bench (45° or less) with feet flat on floor.
2) Position hands on bar wider than shoulder width or lower the unloaded bar to upper chest (where collar bone and sternum joins) and position grip to where forearms are perpendicular to the floor.
3) Start position: Lift bar off rack with bar directly over head.
4) Lower bar to upper chest (where collarbone and sternum joins)
5) Press bar up to starting position.

Bent Knee Barbell Goodmorning

1) Stand with feet shoulder width apart with knees slightly bent (at 20°).
2) Start position: Grasp bar with overhand grip shoulder width apart. Back should be straight in a neutral position.
3) Bending at the hips, lower bar to approximately knee height. Keep knees bent at 20° throughout movement.
4) Return to start position.
5) Remember to keep back straight - movement should occur at the hip. To facilitate this, shift glutes back as if ready to sit down. Knees should not move forward beyond the toes.

Cable Leg Curls

1. Start by standing in front of the machine with one cable strap around 1 leg.
2. Maintaining your balance curl that leg up and back until your foot almost touches your butt.
3. Return to the starting position and repeat for the prescribed repetitions.
4. Repeat with the other leg.

Seated DB Curl and Press on Ball

1. Start by sitting on a resistance ball and holding the dumbells at your sides. Hold the dumbells with your palms up.
2. Curl the dumbells up to shoulder level and then press the dumbells over your head.
3. Return to the starting position and repeat.
4. Keep your abs tight throughout the movement and avoid excessive arching of the lower back.

Bench Dip

1) Sit upright on bench and place hands hip width apart with fingers pointing forward. Place feet flat on opposite bench with legs straight.
2) Start position: Slide glutes off bench with elbows slightly bent.
3) Lower body by bending at elbows until elbows are at 90 degree angle.
4) Return to start position.

Standing Machine Calf Raise

1) Step into provided shoulder pads. Adjust lever arm so that plates do not touch when lowering the weight.
2) Stand with feet hip width apart or stand on the edge of a step on the balls of feet with heels hanging over edge. Toes should be pointing forward.
3) Contract calves by pushing off balls of feet to raise heels up in air (standing on toes)
4) Lower heels and repeat.
5) Remember to keep knees slightly bent throughout movement to prevent any knee strain. Adjust weight load accordingly.

Front Pulldown

1) Adjust seat or knee pad height so that knees are secured while seated.
2) Grasp bar with a overhand grip wider than shoulder width apart and sit with knees secured in pads.
3) Start position: Fully extend arms with elbows facing out with back straight (you may lean back at hips approximately 5°-10°).
4) Pull bar down to upper chest area and squeeze shoulder blades together at end of movement.
5) Return to start position.
6) Remember to keep torso stationary throughout movement.

Double Leg Pressouts

1. Start by lying on your back with your knees towards your chest and your arms flat on the ground.
2. Keeping your back flat throughout the movement kick your legs out and away until they are almost straight.
3. Bring your legs back in and repeat for the required number of repetitions.
4. If you are unable to keep your back flat on the floor throughout the movement shorten the distance that your legs extend until you get stronger.

Lateral Crunch on ball

1. Start by lying on your side across a stability ball with your knees on the ground.
2. Lift your shoulders up laterally so that you perform a side crunch.
3. Return to the starting position and repeat for the required repetitions.
4. Repeat with the other side.